Kontron AT890X Full-Size CLI - Manual (Page 66)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 32
Protected Indicates whether the interface is protected or not. It shows TRUE or
FALSE. If the group is a multiple groups then it shows TRUE in
Group
<groupid>
2.7 GARP Commands
This section describes the commands you use to configure Generic Attribute
Registration Protocol (GARP) and view GARP status. The commands in this section
affect both GARP VLAN Registration Protocol (GVRP) and Garp Multicast
Registration Protocol (GMRP). GARP is a protocol that allows client stations to
register with the switch for membership in VLANS (by using GVMP) or multicast
groups (by using GVMP).
2.7.1 set garp timer join
This command sets the GVRP join time for one port (Interface Config mode) or all
(Global Config mode) and per GARP. Join time is the interval between the
transmission of GARP Protocol Data Units (PDUs) registering (or re-registering)
membership for a VLAN or multicast group. This command has an effect only when
GVRP is enabled. The time is from 10 to 100 (centiseconds). The value 20
centiseconds is 0.2 seconds.
Default 20
Format
set garp timer join <10-100>
Modes Interface Config
Global Config
2.7.1.1 no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the
default and only has an effect when GVRP is enabled.
Format
no set garp timer join
Modes Interface Config
Global Config
2.7.2 set garp timer leave
This command sets the GVRP leave time for one port (Interface Config mode) or all
ports (Global Config mode) and only has an effect when GVRP is enabled. Leave time
is the time to wait after receiving an unregister request for a VLAN or a multicast
group before deleting the VLAN entry. This can be considered a buffer time for
another station to assert registration for the same attribute in order to maintain
uninterrupted service. The leave time is 20 to 600 (centiseconds). The value 60
centiseconds is 0.6 seconds.
Default 60
Format set garp timer leave <20-600>
Modes Interface Config
Global Config