Kontron AT890X Full-Size CLI - Manual (Page 267)

AT8901/2/3 Management Commands
Page 6 - 25 AT8901/2/3 CLI Reference Manual
6.7.1 logging cli-command
This command enables the CLI command logging feature, which enables the
FASTPATH software to log all CLI commands issued on the system.
Default enabled
Format logging cli-command
Mode Global Config
6.7.1.1 no logging cli-command
This command disables the CLI command Logging feature.
Format
no logging cli-command
Mode Global Config
6.8 RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for
authentication and accounting.
6.8.1 radius accounting mode
This command is used to enable the RADIUS accounting function.
Default disabled
Format
radius accounting mode
Mode Global Config
6.8.1.1 no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e.
the RADIUS accounting function is disabled.
Format no radius accounting mode
Mode Global Config
6.8.2 radius server host
This command is used to configure the RADIUS authentication and accounting server.
If you use the
<auth> parameter, the command configures the IP address to use to
connect to a RADIUS authentication server. You can configure up to 3 servers per
RADIUS client. If the maximum number of configured servers is reached, the
command fails until you remove one of the servers by issuing the “no” form of the
command. If you use the optional
<port>
parameter, the command configures the UDP
port number to use when connecting to the configured RADIUS server. The
<port>
number range is 1 - 65535, with 1812 being the default value.
NOTE: To re-configure a RADIUS authentication server to use the default
UDP
<port>
, set the
<port>
parameter to 1812.