Kontron AT890X Full-Size CLI - Manual (Page 96)

Switching Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 2 - 62
report for a particular group in that interface. This value must be less than the IGMP
Query Interval time value. The range is 1 to 3599 seconds.
Default 10 seconds
Format
set igmp maxresponse <1-3599>
Modes Global Config
Interface Config
VLAN Mode
2.15.5.1 no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default
value.
Format no set igmp maxresponse
Modes Global Config
Interface Config
VLAN Mode
2.15.6 set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time. The time is set for
the system, on a particular interface or VLAN. This is the amount of time in seconds
that a switch waits for a query to be received on an interface before the interface is
removed from the list of interfaces with multicast routers attached. The range is 0 to
3600 seconds. A value of 0 indicates an infinite time-out, i.e. no expiration.
Default 0
Format
set igmp mcrtexpiretime <vlanid> <0-3600>
Modes Global Config
Interface Config
2.15.6.1 no set igmp mcrtexpiretime
This command sets the Multicast Router Present Expiration time to 0. The time is set
for the system, on a particular interface or a VLAN.
Format
no set igmp mcrtexpiretime <vlanid>
Modes Global Config
Interface Config
2.15.7 set igmp mrouter
This command configures the VLAN ID for the VLAN that has the multicast router
mode enabled.
Format set igmp mrouter <vlanid>
Mode Interface Config
2.15.7.1 no set igmp mrouter
This command disables multicast router mode for a VLAN with a particular VLAN ID.