Kontron AT890X Full-Size CLI - Manual (Page 139)

AT8901/2/3 Routing Commands
Page 3 - 27 AT8901/2/3 CLI Reference Manual
3.7.11 area nssa translator-stab-intv (OSPF)
This command configures the translator
<stabilityinterval>
of the NSSA. The
<stabilityinterval>
is the period of time that an elected translator continues to
perform its duties after it determines that its translator status has been deposed by
another router.
Format area <areaid> nssa translator-stab-intv <stabilityinter-
val>
Mode Router OSPF Config
3.7.12 area range (OSPF)
This command creates a specified area range for a specified NSSA. The
<ipaddr>
is a
valid IP address. The
<subnetmask>
is a valid subnet mask. The LSDB type must be
specified by either
summarylink
or
nssaexternallink
, and the advertising of the area
range can be allowed or suppressed.
Format
area <areaid> range <ipaddr> <subnetmask> {summarylink |
nssaexternallink} [advertise | not-advertise]
Mode Router OSPF Config
3.7.12.1 no area range
This command deletes a specified area range. The
<ipaddr>
is a valid IP address. The
<subnetmask>
is a valid subnet mask.
Format no area <areaid> range <ipaddr> <subnetmask>
Mode Router OSPF Config
3.7.13 area stub (OSPF)
This command creates a stub area for the specified area ID. A stub area is characterized
by the fact that AS External LSAs are not propagated into the area. Removing AS
External LSAs and Summary LSAs can significantly reduce the link state database of
routers within the stub area.
Format
area <areaid> stub
Mode Router OSPF Config
3.7.13.1 no area stub
This command deletes a stub area for the specified area ID.
Format
no area <areaid> stub
Mode Router OSPF Config
3.7.14 area stub no-summary (OSPF)
This command configures the Summary LSA mode for the stub area identified by
<areaid>
. Use this command to prevent LSA Summaries from being sent.
Default disabled