Kontron AT890X Full-Size CLI - Manual (Page 51)

AT8901/2/3 Switching Commands
Page 2 - 17 AT8901/2/3 CLI Reference Manual
Configuration Name Identifier used to identify the configuration currently being
used.
Configuration Revision Level Identifier used to identify the configuration currently
being used.
Configuration Digest Key Identifier used to identify the configuration currently
being used.
MST Instances List of all multiple spanning tree instances configured on the switch
2.2.24 show spanning-tree vlan
This command displays the association between a VLAN and a multiple spanning tree
instance. The
<vlanid>
corresponds to an existing VLAN ID.
Format
show spanning-tree vlan <vlanid>
Modes Privileged EXEC
User EXEC
VLAN Identifier The VLANs associated with the selected MST instance.
Associated Instance Identifier for the associated multiple spanning tree instance or
“CST” if associated with the common and internal spanning tree.
2.3 VLAN Commands
This section describes the commands you use to configure VLAN settings.
2.3.1 vlan database
This command gives you access to the VLAN Config mode, which allows you to
configure VLAN characteristics.
Format
vlan database
Mode Privileged EXEC
2.3.2 network mgmt_vlan
This command configures the Management VLAN ID.
Default 1
Format
network mgmt_vlan <1-4069>
Mode Privileged EXEC
2.3.2.1 no network mgmt_vlan
This command sets the Management VLAN ID to the default.
Format no network mgmt_vlan
Mode Privileged EXEC