Kontron AT890X Full-Size CLI - Manual (Page 67)

AT8901/2/3 Switching Commands
Page 2 - 33 AT8901/2/3 CLI Reference Manual
2.7.2.1 no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and
only has an effect when GVRP is enabled.
Format no set garp timer leave
Modes Interface Config
Global Config
2.7.3 set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in
order to maintain registration. The value applies per port and per GARP participation.
The time may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is
10 seconds. You can use this command on all ports (Global Config mode) or a single
port (Interface Config mode), and it only has an effect only when GVRP is enabled.
Default 1000
Format
set garp timer leaveall <200-6000>
Modes Interface Config
Global Config
2.7.3.1 no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only
has an effect when GVRP is enabled.
Format no set garp timer leaveall
Modes Interface Config
Global Config
2.7.4 show garp
This command displays GARP information.
Format
show garp
Modes Privileged EXEC
User EXEC
GMRP Admin Mode This displays the administrative mode of GARP Multicast Reg-
istration Protocol (GMRP) for the system.
GVRP Admin Mode This displays the administrative mode of GARP VLAN Regis-
tration Protocol (GVRP) for the system
2.8 GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on
trunk ports and automatic VLAN pruning.