Kontron AT890X Full-Size CLI - Manual (Page 219)

AT8901/2/3 Utility Commands
Page 5 - 21 AT8901/2/3 CLI Reference Manual
keywords:
emergency
(0),
alert
(1),
critical
(2),
error
(3),
warning
(4),
notice
(5),
info
(6), or
debug
(7).
Default disabled; critical when enabled
Format
logging console [severitylevel]
Mode Global Config
5.5.3.1 no logging console
This command disables logging to the console.
Format
no logging console
Mode Global Config
5.5.4 logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr>
is the IP address of the logging host. The
<port>
value is a port number from
1 to 65535. You can specify the
<severitylevel>
value as either an integer from 0 to
7 or symbolically through one of the following keywords: emergency (0), alert (1),
critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Default port—514
level—critical (2)
Format logging host <ipaddr> [<port>][<severitylevel>]
Mode Global Config
5.5.5 logging host remove
This command disables logging to host. See 5.5.10 “show logging hosts” on page 5 -
23 for a list of host indexes.
Format
logging host remove <hostindex>
Mode Global Config
5.5.6 logging port
This command sets the local port number of the LOG client for logging messages. The
<portid>
can be in the range from 1 to 65535.
Default 514
Format
logging port <portid>
Mode Global Config
5.5.6.1 no logging port
This command resets the local logging port to the default.
Format
no logging port
Mode Global Config