Kontron AT890X Full-Size CLI - Manual (Page 136)

Routing Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 24
3.6.5 bootpdhcprelay serverip
This command configures the server IP Address for BootP/DHCP Relay on the system.
The <
ipaddr
> parameter is an IP address in a 4-digit dotted decimal format.
Default 0.0.0.0
Format bootpdhcprelay serverip <ipaddr>
Mode Global Config
3.6.5.1 no bootpdhcprelay serverip
This command configures the default server IP Address for BootP/DHCP Relay on the
system.
Format
no bootpdhcprelay serverip
Mode Global Config
3.6.6 show bootpdhcprelay
This command displays the BootP/DHCP Relay information.
Format show bootpdhcprelay
Modes Privileged EXEC
User EXEC
Maximum Hop Count Is the maximum allowable relay agent hops.
Minimum Wait Time (Seconds) Is the minimum wait time.
Admin Mode Represents whether relaying of requests is enabled or disabled.
Server IP Address Is the IP Address for the BootP/DHCP Relay server.
Circuit Id Option Mode Is the DHCP circuit Id option which may be enabled or dis-
abled.
Requests Received Is the number or requests received.
Requests Relayed Is the number of requests relayed.
Packets Discarded Is the number of packets discarded.
3.7 Open Shortest Path First (OSPF) Commands
This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.
3.7.1 router ospf
Use this command to enter Router OSPF mode.
Format router ospf
Mode Global Config
3.7.2 enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).