Super Systems 3 Series - Manual (Page 22)

Operations Manual Series 3
22
Mnemonic Scrolling Display and description Range
WKG.SP WORKING SETPOINT is the active setpoint value and appears when the controller is
in Manual mode. It may be derived from SP1 or SP2, or, if the controller is ramping
(see SP.RAT), it is the current ramp value. SP.HI to SP.LO
WRK.OP WORKING OUTPUT is the output from the controller expressed as a percentage of
full output. It appears when the controller is in Auto mode.
For a time proportioning output, 50% = relay or logic output on or off for equal
lengths of time.
For On/Off control: OFF = <1%. ON = >1% Read only value
0 to 100% for heating
0 to –100% for cooling
-100 (max cooling) to 100% (max
heating
T.STAT FEATURE UNAVAILABLE Reset rES
Running run
Hold hoLd
End Timed out
UNITS DISPLAY UNITS Temperature display units. ‘Percentage’ is provided for linear
inputs O C Degrees C
O F Degrees F
O k Degrees K
nonE None
PErc Percentage
SP.HI SETPOINT HIGH High setpoint limit applied to SP1 and SP2. Alterable between range limits
SP.LO SETPOINT LOW Low setpoint limit applied to SP1 and SP2
By default the remote setpoint is scaled between SP.HI and SP.LO. Two further parameters (REM.HI and REM.LO) are
available in access level 3 to limit the Remote SP range if required.
SP1 SETPOINT 1 allows control setpoint 1 value to be adjusted Alterable: SP.HI to SP.LO
SP2 SETPOINT 2 allows control setpoint 2 value to be adjusted Alterable: SP.HI to SP.LO
SP.RAT SETPOINT RATE LIMIT Rate of change of setpoint value. OFF to 3000 display units per
minute
The next section applies to the Timer only.
TM.CFG FEATURE UNAVAILABLE none None
Dwel Dwell
DeLy Delayed switch on
sfst Soft start
TM.RES FEATURE UNAVAILABLE Hour
min
Hours
Minutes
THRES FEATURE UNAVAILABLE OFF or 1 to 3000
END.T FEATURE UNAVAILABLE OFF Control OP goes to zero
Dwel Control continues at SP1
SP2 Go to SP2
SS.PWR FEATURE UNAVAILABLE -100 to 100%
SS.SP FEATURE UNAVAILABLE Between SP.HI and SP.LO
DWELL FEATURE UNAVAILABLE 0:00 to 99.59 hh:mm: or mm:ss
T.REMN FEATURE UNAVAILABLE 0:00 to 99.59 hh:mm: or mm:ss
The following parameters are available when the timer is configured as a programmer.
SERVO FEATURE UNAVAILABLE SP Setpoint
PV Process variable
SP.rb Ramp back to SP
PV.rb Ramp back to PV
TSP.1 TARGET SETPOINT 1. To set the target value for the first setpoint
RMP.1 FEATURE UNAVAILABLE OFF, 0:01 to 3000 units per min or
hour as set by TM.RES