Super Systems 3 Series - Manual (Page 6)

Operations Manual Series 3
6
Installation and Basic Operation What Instrument Do I Have?
Thank you for choosing this Series 3 Temperature Controller.
The Series 3 provides precise temperature control of
industrial processes and is available in one standard DIN size:
•
1/4 DIN
A universal input accepts various thermocouples, RTDs or
process inputs. Up to four outputs can be configured for
control, alarm or re-transmission purposes. 485
communication is also available.
The controller may have been ordered pre-configured or
setup with defualt configuration..
If the display shows SET 1 the controller was supplied
without parameters and will need to be configured when it
is first switched on.
This Manual takes you through all aspects of installation,
wiring, configuration and use of the controller.
1.1 Unpacking Your Controller
The controller is supplied with
•
Sleeve (with the controller fitted in the sleeve)
• Two panel retaining clips and sealing gasket mounted
on the sleeve
• Component packet containing a snubber for relay
output and a 2.49Ω resistor for current inputs.
1.2 Dimensions
General views of the controller are shown below together
with overall dimensions.