FARGO electronic HDP600-LC CR100 - Manual (Page 115)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-15
General Troubleshooting Guide (continued)
Problem Possible Solution
Ribbon Sticking to
the Film Increase the Ribbon Tension. See the Adjusting the Ribbon
Tension procedure.
Film is only printing
on the back half of
the card Check to see if the Lamination Lift Motor (D840980) is rotating in
the correct direction.
Continued on the next page