Section 10: board level diagnostics, Board errors, Resolving the ee memory error – FARGO electronic HDP600-LC CR100 User Manual
Page 355: Resolving the ee checksum error, Section 10: board level diagnostics -1, Board errors -1, Resolving the ee memory error -1, Resolving the ee checksum error -1
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
10-1
Section 10: Board Level Diagnostics
Important: The procedures in this section apply for the HDP600/HDP600-LC and
HDP600 CR100/HDP600-LC CR100 Card Printers.
The purpose of this section to provide the User with specific Board Level Diagnostic
procedures for Board Errors and Sensor Testing for the HDP600.
Board Errors
Resolving the EE Memory Error
Symptom: An error has occurred in the permanent circuit memory. (Note: The Printer’s
LCD will state the following: EEPROM ERASED.)
Step Procedure
1
Reboot the Printer.
2
If the problem persists, the Main Print Board will need to be replaced.
3
As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)
Resolving the EE Checksum Error
Symptom: An error has occurred in the permanent circuit memory.
Step Procedure
1
Reboot the Printer.
2
If the problem persists, the Main Print Board will need to be replaced.
3
As an alternative to replacing the Main Print Board, the chip U21 may be
replaced. (Note: Fargo recommends that only a qualified electronics
technician perform this procedure.)