FARGO electronic HDP600-LC CR100 - Manual (Page 165)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-65
Resolving a Headlift Motor or Sensor Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: The Printhead continuously cycles or does not cycle at all
• Printer Error State: Headlift Sensor is not detecting movement from the
Headlift Cam.
• LCD Error Display: Headlift Error
• Driver Monitor Error Display: General Error
2 Press the Cancel Print button on the Driver Monitor Error Display Message.