FARGO electronic HDP600-LC CR100 - Manual (Page 194)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-94
Running the Self Test
Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has
been conducted, or (c) a part has been replaced to check for proper Printer operation.
Step Procedure
1 Verify that a full-color or Premium Resin Ribbon is installed and that cards
are properly loaded.
Caution: If the power is ON, disconnect the Power Cable from the
Printer’s rear panel.
2 Press and hold the Pause/Resume button.
3 While holding down the Pause/Resume button, plug the power cable back
into the Printer.
4
• Full Color Ribbon installed: The Printer will print a 3-color process gray
scale on the front of the card. The overlay pass is not printed during the
Self-test. See the next page.
• Premium Resin Ribbon installed: The Printer will print a single color gray
scale on the front of the card. See the next page.)