Resolving the image placement problems – FARGO electronic HDP600-LC CR100 User Manual
Page 192
Advertising
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
4-92
Resolving the Image Placement problems
Step Procedure
4
Verify if the Vertical Image Position Setting is set correctly or incorrectly.
See the graphic below.
• If the white border is on the top edge of the card, adjust the Vertical
value by +2.
• If the white border is on the botom edge of the card, adjust the
Vertical value by -2.
a. Click
on
OK.
b. Run a self-test.
c. If the white border is diminished, continue the adjustment until it is gone.
Advertising