FARGO electronic HDP600-LC CR100 - Manual (Page 44)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 2-26
Printer Components: Transfer Roller
Danger: The Printer’s Transfer Roller can reach temperatures exceeding 350
degree F (175 C). Use extreme caution when operating the Transfer Roller. Never touch the
Lamination Roller unless the Printer Power has been turned off for at least 20 to 30 minutes.
Type Description
Controls Both the Printer itself and the Printer’s software Driver control the
built-in Transfer Roller.
Temperature
Adjustment To change the temperature of the Transfer Roller, adjust its
temperature through the Image Transfer within the Printer Driver
setup window.
Once adjusted, the new temperature settings will be sent down with
the next print job along with the rest of the Printer Driver information.
New
Temperature
Setting Before printing begins, the Transfer Roller will automatically adjust
itself to the new temperature setting. (Note: This new temperature
setting will remain programmed within the Printer until it is once again
changed within the Printer Driver or until the Printer is turned OFF.)
Whenever the Printer is turned OFF, the Transfer Roller will
automatically reset itself and return to its default temperature the next
time the Printer is turned ON.
Flip the Power Switch to OFF.
OR
Disconnect the Printer's power supply. (Technician Note: Both the
Power Switch and the Printer’s power supply serve to reset the
Transfer Roller to its default temperature. The temperature setting
within the Printer Driver, however, will stay the same until it is
changed.)