FARGO electronic HDP600-LC CR100 - Manual (Page 127)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-27
Resolving a Card Not Fed Error (Two (2) or more card feed at the
same time)
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptoms: Two or more cards feed at the same time causing the
cards to jam at the Card Hopper Roller. Printer is out of cards.
• Printer Error State: Card is not being detected by card TOF Sensor 11
sec after the initiation of a print job causing the Printer to produce an
error
• LCD Error Display: Card Not Fed
• Driver Monitor Error Display: Unable to Feed Card