FARGO electronic HDP600-LC CR100 User Manual
Page 15
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
1-6
Reviewing HDP
® 600 Series Card Printer - Sequence of Operations (continued)
Step Process
23
The Stepper and Film Drive engage to laminate the printed Film onto the card.
They will turn off after a given number of steps based on the position given by the
Card Sensor. All stop. (Note: The Film Encoder is active during this step.)
24
The Transfer Roller Motor turns ON to raise the Transfer Roller and will stop when
the Sensor is activated. All off.
25
The Film Drive and Stepper turn ON for a given number of clicks based on Film
Encoder, until the film is released.
26
The Stepper turns ON to move the card into the Output Hopper (based on steps
from a known position). All stop.
27
The Heater and Thermocouple are maintained at a set temperature at all times
when the Printer is ON. The cooling fan is ON when the Printhead is ON or hot.