FARGO electronic HDP600-LC CR100 - Manual (Page 389)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 11-29
Adjusting the LAM TOF and EOF
Step Procedure
1 Applies only if the Printer is equipped with the Card Lamination Module.
• Use this control to align the PolyGuard Overlaminate patch on the card.
Decrease the Lamination TOF value to move the overlaminate patch more
toward the leading edge of the card.
• TOF will not move the patch. It adjusts when the head lifts after patch has
been applied.
The numbers being entered for the settings are in Pixels. The number of Pixels
is equal to the measurement in inches times 300 or the measurement in mm
times 11.8.
For example, 0.100 inches or 2.54mm equals 30 increments on the LCD. Once
adjusted, this value will be stored in the Lamination Module. (Note: This
adjustment can also be made more easily through the Printer Driver, but it will
not be stored in the Lamination Module.)
Direction card travels through printer
Rear of Printer
Card Output
Side of Printer
(Leading Edge
of Card)
Card Input
Side of Printer
(Trailing Edge
of Card)
Front of Printer