FARGO electronic HDP600-LC CR100 - Manual (Page 248)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 5-52
Upgrading the Main Firmware with the Fargo
Diagnostics Utility
The Printer Server Firmware upgrades for the DTC400/HDP600 are done from the Upgrade
web page for the Printer. See the Upgrade web page description.
The Main Printer Firmware upgrades are done with the same procedure as the USB-
connected Printer. (Note: The PC doing the upgrade must have a Driver installed for the
Fargo Printer to be upgraded.)
Step Procedure
1 Run the Fargo Diagnostic Utility by selecting from the start menu the following:
Start -> Programs -> Fargo -> Fargo Diagnostic Utility
2 Select the Fargo Printer to upgrade from the drop-down box.
3 Go to the Firmware Updates tab.
4 If you need to download the update file from the Internet, then select the
Download Firmware button.
5 Choose the update file with the Select Firmware button.
6 Put your Printer into the upgrade mode. Refer to the appropriate service
manual for your specific Fargo Card Printer.
7 Select the Send Firmware button.