FARGO electronic HDP600-LC CR100 - Manual (Page 168)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-68
Resolving the Cover Open Error Message
Step Procedure
2 Check for debris, as follows:
a. Open the front cover and check that no debris has accumulated in the
lid Sensor opening. Use compressed air to clean the opening id as
needed.
b. If the Sensor still does not work, continue to Step 3.
3 Check that the Sensor tab on the front cover is not damaged.
a. Open the front cover and examine the Lid Sensor tab for damage, if the
Sensor tab is damaged, replace the front cover. (Note: See the current
HDP600 Service Manual for related instructions in the Parts
Replacement Section.)
b. If the Sensor still does not work, continue to Step 4.
4 Replace the Main Board. (Note: See the current HDP600 Service Manual
for related instructions in the Parts Replacement Section.)