Aligning the print offset, Procedure – FARGO electronic HDP600-LC CR100 User Manual
Page 368
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
11-8
Preparing to Adjust the Print Offset, Transfer TOF and Transfer EOF
Step Procedure
1
Before starting the alignment procedures, you must first establish a baseline
from which to start the adjustments.
Before adjusting the Print Offset, TOF and EOF, the Print and Transfer Film
Sensors should be calibrated.
• Ensure that the Film is loaded into the Printer and that no Film marks are
resting under Sensors.
• Close the Lid and all other covers.
• From the Sensor Calibration menu, select Calib Film Sensors. The Printer
will then calibrate the Sensors automatically.
2 Select
MENU, Setup Printer, Print Settings.
3 Select
the
Print Offset button.
4
Set baseline for CR-80 to -15 and CR-100 to -30 and press the Select button.
5 Select
Transfer TOF.
6
Set to +40 and press the Select button.
7 Select
the
Transfer EOF button.
8
Set to ZERO and press the Select button.