FARGO electronic HDP600-LC CR100 - Manual (Page 196)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-96
Running the Magnetic Self Test (HiCo Only)
Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has
been conducted, or (c) a part has been replaced to check for proper Printer operation.
Step Procedure
1 Remove Ribbon from the Printer and close the front cover
2 Go to the LCD screen on your Printer. (Important: This option is only
available if the Magnetic Encoder is installed.)
a. Select MENU from the LCD.
b. Select Print Test Image.
c. Select Magnetic Test.
3 The Printer will Encode magnetic information on all 3 magnetic tracks