FARGO electronic HDP600-LC CR100 - Manual (Page 387)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 11-27
Adjusting the Flipper Offset
Step Procedure
1 Select MENU, Setup Printer and Flipper Offset.
2 Change the setting in small increments if the card is not feeding correctly. (Note:
A negative adjustment will lower the side of the Flipper Table closest to the Input
Hopper.)
There are five (5) settings under the Flipper Settings Menu:
• Mag/Prox
• Level
• Smart
• Inverted
• Home
See the Menu Tree in this section for their use. All settings can be tested from
this Menu.
3 Press the Save button to save the value.