FARGO electronic HDP600-LC CR100 User Manual
Page 5
RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5)
v
Resolving the Blank Output issues ___________________________________________________ 4-69
Card Lamination Errors______________________________________________________________ 4-72
Resolving a Laminator (General Error) _______________________________________________ 4-72
Resolving the Laminator (Check Power) Error _________________________________________ 4-73
Resolving the Laminator (Heater Off) Error ___________________________________________ 4-74
Resolving the Wrong Overlaminate Installed Error ______________________________________ 4-75
Resolving Check Lamination Material Error ___________________________________________ 4-76
Diagnosing Image Problems __________________________________________________________ 4-77
Resolving the Pixel Failure problems _________________________________________________ 4-77
Resolving the Card Surface Debris problems ___________________________________________ 4-78
Resolving the Incorrect Image Darkness problems ______________________________________ 4-79
Resolving the Ribbon Wrinkle problems ______________________________________________ 4-82
Resolving the Excessive Resin Printing problems _______________________________________ 4-84
Resolving the Incomplete Resin Printing problems ______________________________________ 4-87
Resolving the Image Placement problems _____________________________________________ 4-89
Resolving the Poor Image Quality problems ___________________________________________ 4-93
Running the Self Test _______________________________________________________________ 4-94
Running the Standard Self Test Print _________________________________________________ 4-95
Running the Magnetic Self Test (HiCo Only) __________________________________________ 4-96
Section 5: Ethernet Option Section ___________________________________________ 5-1
Introduction ________________________________________________________________________ 5-1
Technical Specification - Ethernet Option ________________________________________________ 5-1
Functional Specification - Ethernet Option ________________________________________________ 5-2
Network Services - Overview ____________________________________________________5-3
Reviewing the Print Server__________________________________________________________ 5-3
Reviewing the Web Page Server _____________________________________________________ 5-3
Reviewing the Network Management Interface __________________________________________ 5-3
Reviewing the Telnet Server ________________________________________________________ 5-3
Network Management Interface _________________________________________________5-4
Telnet Command Line Interface _________________________________________________5-4
Initiating a Telnet Session __________________________________________________________ 5-4
Reviewing the Telnet Command Table ________________________________________________ 5-5
Ethernet Web Pages – Standard Procedures ______________________________________5-11
Reviewing Web page security _________________________________________________________ 5-11
Logging In ________________________________________________________________________ 5-12
Accessing the Home pages ___________________________________________________________ 5-13
Reviewing the HDP600 Home Page__________________________________________________ 5-14
Reviewing the Home Page Categories and Fields (table)__________________________________ 5-15
Configuring the Network Settings______________________________________________________ 5-16
Accessing the Network Settings page_________________________________________________ 5-16
Reviewing the Interface ___________________________________________________________ 5-17
Reviewing the Current Settings _____________________________________________________ 5-18
Switching to the automatic IP address mode ___________________________________________ 5-19
Changing to the static IP address mode _______________________________________________ 5-20
Entering the TCP Window Size _____________________________________________________ 5-22
Using the Clear Changes button _____________________________________________________ 5-23
Using the TCP/IP page ______________________________________________________________ 5-24
Using the TCP/IP Status Web Page __________________________________________________ 5-25
Using the Printer page _______________________________________________________________ 5-26
Using the System Log page___________________________________________________________ 5-28
Changing the Log Name___________________________________________________________ 5-29
Selecting the Log Type____________________________________________________________ 5-31
Setting up Email Event logging _____________________________________________________ 5-33