FARGO electronic HDP600-LC CR100 - Manual (Page 48)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 3-2
Introduction
Important: The procedures in this section apply for the HDP600/HDP600-LC and
HDP600 CR100/HDP600-LC CR100.
The following guide will walk you through the installation of the Fargo HDP600 Driver.
Time Requirement
This software installation process will require approximately 2 to 6 minutes (depending on the
speed of your PC).
System Requirements
The System Requirements are as follows:
• IBM-PC or compatible, Windows® 2K/XP, Pentium® class 133MHz computer with 64MB
of RAM or higher, 200MB free hard disk space or higher, USB 1.1
(Note: The Printer will be available with parallel port.)
Inspection – HDP600
While unpacking your Printer, inspect the carton to ensure that no damage has occurred
during shipping. Make sure that all supplied accessories are included with your unit.
Unpacking the Printer
The following items are included with your Printer:
• Unpacking instructions and Setup video CD
• Software Installation CD (includes Printer Driver, Online User’s Guide and Printer
Diagnostic Tool)
• Power Supply with Power Cord
• Card Cleaning Cartridge
• Two (2) Card Hoppers - Feed Weights (only one for the HDP600 CR100 and HDP600-LC
CR100)
• Warranty
Card
• Registration
Card
• Sample Pack of 25 Ultra Card III (not included with the HDP600 CR100 and HDP600-LC
CR100)
This is included with the HDP600-LC Only:
• Card Lamination Module - Power Supply with Power Cord