FARGO electronic HDP600-LC CR100 - Manual (Page 160)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.5) 4-60
Resolving a No Ribbon Installed Error
Step Procedure
2 Verify that a Ribbon is installed in the Printer.
a. Press on the Resume button.
b. If the issue persist, continue to Step 3.
3 Remove the rear cover and check that the Ribbon RFID cable is securely
connected to the Main Board (J-5) and the RFID Sensor.
• If the connections are loose, reattach them.
• Press on the Resume button.
• If the connections are good or if the issue persists, continue to Step 4.
4 Replace the Ribbon RFID Sensor.