Sony OXF-R3 - Manual (Page 104)

4-44
Chapter 4 Signal Paths
Chapter 4 Signal Paths
4-13 Multi-Stem Set-up
Behaviour of Routing in general.
The routing options and behaviour vary considerably depending on
whether the system is operating in STEREO or MULTI-FORMAT modes.
What follows is a summary:
STEREO Mode
‘ROUTE TO TRACKS’ section 3 allows panning strictly between Odd
and Even tracks only. MULTI-FORMAT buttons 2 are not operational.
• Selecting either just ODD or EVEN tracks.
A Post Fader signal will be fed directly to the Odd or Even tracks. The
M/T {PAN IN} button is not operational.
• Selecting at least one ODD and one EVEN track.
A Post Fader signal will be fed directly to the Odd and Even tracks.
Selecting the M/T {PAN IN} button will allow panning between the Odd
and Even tracks.
MULTI-FORMAT Mode
Routing to busses can be accomplished in several ways:
• Using the MULTI-FORMAT section buttons 2 at the top of the panel,
which are mapped onto the track buttons stem by stem.
• Using the ‘ROUTE TO TRACKS’ buttons directly.
• A mixture of the two above to multiple stems.
ROUTING SELECTIONS for the ACTIVE STEM
The ‘Active Stem’ is the one selected and lit in section 1.
• Selecting a single button in the MULTI-FORMAT section 2
The track button, one of 1-48, mapped in the stem set-up to the one
pressed, will light and a Post Fader signal will be fed directly to that
track. The M/T {PAN IN} button is not operational.
• Selecting two buttons in the MULTI-FORMAT section 2
The track buttons, two of 1-48, mapped in the stem set-up will light and a
Post Fader signal will be fed directly to those tracks. Selecting the M/T
{PAN IN} button will allow panning between those tracks, using the PAN
in the Multitrack panel or the Definable knobs, one above each fader.
The full range of the PAN knob is operational between the tracks whilst
the Motorised Joystick will be mapped to the shortest path. If the
Joystick is moved out of that path it will spring back when released.
Note
The {JOYSTICK EN} button must be selected in the centre section for the Joysticks
to be operational.