Sony OXF-R3 - Manual (Page 344)

7-84
Chapter 7 Session Management
Chapter 7 Session Management
7-8 Offline Automation
OFFLINE FADERS automation edit GUI
7-8 Offline Automation
This screen page allows automation data for Faders and Cuts to be written and modified offline. Click on either
FADERS or CUTS as required.
General
This GUI allows the editing of automation data for
selected faders with new or trimmed levels between
specified times. Similarly new cut events can be
written between specified times and cut transitions can
be time-shifted.
A number of fields in the GUI apply to both
Faders and Cuts. These are described first:
Control type Selector
Situated in the upper left, this allows selection of fader
and cut type e.g. Channel Faders, Control Groups.
Numbers field
Allows selection of channels to work on, according to
the control type highlighted in the upper left selector.
Upper Timecode bar
Indicates the current timecode for the master machine.
FM, TO and DURATION
This field (upper centre) allows the start time, end time
and duration of an offline operation to be set. This
field may also be used to specify a butt or ramp in and
out (faders only).
C/GROUP DATA TO SLAVES
This section (top right of screen) allows control group
data to be propagated to slaves. NEXT LAYER
propagates to the next lowest layer. ALL LAYERS
propagates to all layers of nested groups such that
channel faders alone retain the move and cut data.