Sony OXF-R3 - Manual (Page 70)

4-10
Chapter 4 Signal Paths
Chapter 4 Signal Paths
4-7 SEND 1 Pre Fader Headphones Feed
The diagram shows a typical Pre Fader headphone mix set-up, where a
channel is configured in multitrack mode. SEND 1 is used to send a signal
to headphones from the tape return signal. As the signal path indicates in
the diagram, the headphones are positioned after the dynamics function
sourced from the monitor path, pre fader.
To achieve this, on the upper section of the SENDS 1-24 panel, first make
sure that SEND 1 is selected in the ‘SELECT SOURCE FOR’ display
(upper right in the SENDS 1-24 panel). If not, use the large { + } and { - }
buttons to select SEND 1. Then, in the left hand display window of the
same panel, use the small { + } and { - } buttons to display - 8 - which will
cause the {SELECT} button to light. Press the {SELECT} button and its light
goes out to confirm the new source point. The source for SEND 1 bus is
now fed from the output side of the channel path window displaying - 8 -.
This procedure may be used for each SEND bus, allowing the source point
to be from any junction within the channel signal path, not just pre and
post fader, as with the majority of analogue consoles.
SEND 1 pre fader headphones feed
Global select Source for all channels
First select the ACCESS button on the Main fader. Then select the
appropriate source point in the SOURCE display in the upper right
section of the SENDS 1-24 panel using the + and - buttons. Then press
the {SELECT} button in the same section to set that source for all
channels.
SENDS 1-24
INPUT CHANNEL & INSERTS
CH INPUT
8
SOURCE
SELECT
MIC IN
IN
IN IN
IN IN
GAIN
MIC
M/T
LINE
SELECT SOURCE FOR
1
ш
ш
– 20 dB F I L T E R 2 E Q
F I L T E R 2 E Q
8 7 D Y N
M U L T I
RETURN
SEND
GAIN
GROUP
TRIM
M/T
SEND
ROUTING
I N S E R T
I N S E R T
C H O U T P U T
M U L T I D Y N 7
IN
MAIN
IN
SEND RETURN
PAN
CHANNEL
FADER
AUX 1
L & R
8
Upper section of
SENDS 1-24 panel
in channels sections
4-7 SEND 1 Pre Fader Headphones Feed