Sony OXF-R3 - Manual (Page 347)

Chapter 7 Session Management
7-87
Chapter 7 Session Management
Note:
COMMIT
Commit is used to confirm actions as necessary.
MIN LIST
The list of cut events can be minimised where events
occur at exactly the same timecode.
FULL LIST
Every cut event is displayed individually, even if it
occurred at the same timecode as other events. This
allows adjustment of every individual event.
OFFLINE CUTS EDIT PROCEDURE
To select Fader Cuts
For Channel cuts, click on CHANS in the selector
block. It highlights red and the channels are displayed
in the numbers field.
To set the Cuts to be worked on
Click VIEW and it highlights. Then click on the
channels to be worked on and they highlight red.
Click on them again to de-select them individually.
This procedure also applies to MTSEND, GROUPS
and SSGs.
To select Send Cuts
For Send Cuts for a particular channel, click on
CHSEND; it highlights red and the channels are
displayed in the numbers field. Click on the required
channel and its Sends, 1-24, are displayed in the
numbers field. Click on the required Sends and they
highlight red.
For a mix of all channels for a particular Send bus,
click on SNDMIX; it highlights red and Sends 1-24 are
displayed in the numbers field. Click on the required
Send and the channels are displayed in the numbers
field. Click on the required channels and they
highlight red.
Using ALL, NONE and RANGE
To select all cuts of any type, click on ALL and all
numbers will be highlighted red. ALL will change to
NONE.
To select a number of consecutive cuts, click on
RANGE then click, one at a time, on both ends of the
range. Separate ranges may co-exist.
Once the desired cut type and numbers have been
selected, click on VIEW again to de-select it. Any
events related to the cuts selected in VIEW mode will
be displayed in the Cues list.
Cut EVENT edit
EVENT mode is the default and it will highlight red.
Cut events for the selection will be displayed in the list
along with the cues, and the current state of the cuts
will be indicated in the numbers field according to the
following colour coding:
BLUE • Uncut without any data written
WHITE • Uncut controlled by the automation
AMBER • Cut controlled by the automation
RED RING • Cut event(s) at the current timecode
Note
A red ring around the outside of a number box indicates the
first timecode point for the new state, cut or uncut.
Automated cut events will be displayed in the numbers
field as the tape is rolling and their entry in the cues
list will also be highlighted.
Note
The GUI display has a lower priority than the cut events and
therefore the screen may not react in real time as the tape is
rolling.
New EVENT Cuts
Any cuts selected using VIEW which have no
automation data (blue coding) can be automated using
this GUI. Click on a channel to cycle through:
RED • Cut from the highlighted timecode
WHITE • Uncut from the highlighted timecode
BLUE • No automation
To Nudge or Change a Cut Event Time
Highlight its timecode entry in the cues list, then use
the { + } and { - } buttons on the control keyboard to
change the time. Alternatively, click on its timecode
for a pop-up and nudge to adjust or type in a new
timecode.