Sony OXF-R3 - Manual (Page 79)

Chapter 4 Signal Paths
4-19
Chapter 4 Signal Paths
Dynamics Side-Chain Link Right set-up procedure
The buttons for this operation are located in the Free Assign Area &
Dynamics panel. They are the assignable buttons just left of centre in the
upper section of this panel. Their function is indicated by individual 8
character displays, one positioned to the left of each button (see Chapter 6,
section 6-2-6).
There are two 8 character displays which relate to this function, and the
fire-up default is LOCAL in both. The upper display indicates the
destination for the Side-Chain Signal generated by the current channel.
The lower display indicates the source for the Side-Chain Signal for the
current channel.
Set-up procedure
1
The middle button sets where the Side-Chain Control Signal is sent.
The default is LOCAL i.e. to its own channel. Step through the
options with this button and set it at SC TO RT. This setting sends
its Side-Chain Control Signal to the next channel to the right.
2
The lower button sets where the Side-Chain Control Signal is
taken from. The default is LOCAL i.e. from its own channel.
Step through the options with this button and set it at SC FM RT.
With this setting, the current channel takes its Side-Chain Control
Signal from the next channel to the right.
A set-up using 1 and 2 above creates a stereo dynamics section.
3
Repeat 1 and 2 above on further channels as desired.
Note
For correct operation, elements such as GATE, COMPRESSOR etc, must
switched in on each channel involved in this type of group.