Sony OXF-R3 - Manual (Page 203)

Chapter 6 Technical Descriptions
6-41
Chapter 6 Technical Descriptions
5 LS1 Push-Button
Selects the Main Surround Monitor LS set and inter-cancels with LS2.
The Calibration settings, {CAL} button selected on MULTI-FORMAT
panel in the centre section, apply to LS1.
6 LS2 Push-Button
Selects the Secondary Surround Monitor LS set and inter-cancels with LS1.
The Calibration settings do not apply to LS2.
7 LS3 Push-Button
Independent Stereo LS which may be switched on simultaneously with
LS1 or LS2. Once LS3 is selected, LS1 and LS2 can be de-selected.
If LS3 has been selected, and LS1 or LS2 has been de-selected, LS3 can be
de-selected too. This means there will not be any monitor LS signal. As a
warning, the LS1, LS2 and LS3 light red in rotation.
8 7.1 MON Push-Button
Selects the 7.1 output from the input to the Fold-Down Matrix.
“FOLDDOWN” must be selected as a source in the EXT SOURCE section
of the Monitor panel. Its {SELECT} button must also be selected, in order
to monitor this signal.
9 5.1 MON Push-Button
Selects the 5.1 output from the input to the Fold-Down Matrix.
“FOLDDOWN” must be selected as a source in the EXT SOURCE section
of the Monitor panel. Its {SELECT} button must also be selected, in order
to monitor this signal.
!º LCRS MON Push-Button
Selects the LCRS output from the input to the Fold-Down Matrix.
“FOLDDOWN” must be selected as a source in the EXT SOURCE section
of the Monitor panel. Its {SELECT} button must also be selected, in order
to monitor this signal.
!¡ ST MON Push-Button
Selects the STEREO output from the input to the Fold-Down Matrix.
“FOLDDOWN” must be selected as a source in the EXT SOURCE section
of the Monitor panel. Its {SELECT} button must also be selected, in order
to monitor this signal.
!™ MONO MON Push-Button
Selects the MONO output from the input to the Fold-Down Matrix.
“FOLDDOWN” must be selected as a source in the EXT SOURCE section
of the Monitor panel. Its {SELECT} button must also be selected, in order
to monitor this signal.
!£ Ø Push-Button
Selecting Ø sets the individual LS Cuts into a phase reverse mode. It will
flash, lighting orange.
Note: