Sony OXF-R3 - Manual (Page 363)

Chapter 7 Session Management
7-103
Chapter 7 Session Management
VPANEL IS MACHINE CONTROLLER
• Sets the external or virtual panel as the master machine remotes in control
of the R3 and Motionworker or 9-P control.
SHOW REMOTES FRAMES
• Sets the TC display by the transport remotes to display frames.
TRACK ARMING USES GPIO
• Sets Record Ready buttons, one above each channel fader, to control the
GPIO record relays and display the state of tally inputs. The GPIO card
will be installed in one of the I/O racks.
• Selecting NO for this option will cause the Record Ready buttons to
operate on whichever machine control interface is currently in use.
TRACK ARMING FORCES INPUT - 9 PIN ONLY
• Switches tracks into input mode automatically when they are record
enabled.
LOCK DISABLES SHUTDOWN
• Prevents display of the SYSTEM SHUTDOWN pop-up and related
command.
LOCK DISABLES NESTED GROUPS
• This relates to the Control Group Faders 1-32. It prevents the setting up
or alteration to nested Control Groups since this could cause jumps in
level.
AUTOMATION Tab
PLAYBACK WHEN MASTER LOCKED
• Allows playback of automation data with just the master machine locked
to the system. In other words, there is no delay waiting for slave
machines to become synchronised.
The following MUTE Preferences relate to elements which may be set to mute
during partial loading of Snapshots and Mixes preventing any signals being fed to
busses during the load operation. This may be desirable when the new data will
load a significantly different set-up to the current one.
MUTE CHANNELS ON LOAD
• Mutes the Channel Outputs for the channels affected by the loading of a
Snapshot or Mix.
MUTE CH MTSENDS ON LOAD
• Mutes the Channel Multitrack Sends for the channels affected by the
loading of a Snapshot or Mix.
MUTE CHAN INPUTS ON LOAD
• Mutes the Channel Inputs for the channels affected by the loading of a
Snapshot or Mix.
Note: