Sony OXF-R3 - Manual (Page 272)

7-12
Chapter 7 Session Management
Chapter 7 Session Management
7-5 Mixing Overview
To set a cue point offline
1
Move the orange highlight to the desired line in the
TIME column on the screen.
2
Click or press {EDIT} on the Control Keyboard.
Type in the timecode and click OK or press
{ENTER} on the Control Keyboard.
To adjust the time of a cue point offline
1
Move the orange highlight to the TIME column on
the screen and nudge the time with the { + } and
{ - } keys, or:
2
Click on the time entry or press {EDIT} on the
Control Keyboard to display the timecode dialogue
box. Type in the timecode and click OK or press
{ENTER} on the Control Keyboard.
Using the Numeric Key-pad to Enter Timecode
The entry format is exactly the same as that used for
PCM-3324/48 series remote control units:
1 = 00:00:01:- -
12 = 00:00:12:- -
1234 = 00:12:34:- -
12345 = 01:23:45:- -
123456 = 12:34:56:- -
12345621 = 12:34:56:21
12:34:56:21 = 12:34:56:21
12:34:56 = 12:34:56:- -
Timecode shortforms:
:: Separates hours/minutes
: Separates minutes/seconds
. Separates seconds/frame
12:: = 12:00:00:00 Specifies hours
34: = 00:34:00:00 Specifies minutes
56 = 00:00:56:00 Specifies seconds
.21 = 00:00:00:21 Specifies frames
To obtain a rough balance
1
On the Control Keyboard, press:
{CYCLE} {TITLE}
{ENTER}
The source material will be repeated over and over
again between the Start and End times allowing a
fader balance to be created.
Alternatively, press:
{CYCLE} {CUE} # {CUE} # {ENTER}
to use cue numbers for the selection.
2
Stop the tape when required using the Machine
Remote transport
p stop key or press {CANCEL}
on the Control Keyboard.
3
To repeat the operation, press:
{REPEAT} {ENTER} on the Control Keyboard.