Sony OXF-R3 - Manual (Page 85)

Chapter 4 Signal Paths
4-25
Chapter 4 Signal Paths
2
While the system is unlocked, press the {SET MAIN WIDTH} button to
check the Main Bus width matches requirements, if not already
displayed.
3
To change it, while the system is unlocked, use the { + } or { - } button
to step through the formats: STEREO, LCRS, 5.1 and 7.1 until the
desired format is displayed by the 8 character dot display above the
{LOCK} push-button. It will also be displayed above the central Master
Fader.
Main Bus to Multitrack
As well as feeding the Main Output to external destinations, the system
allows the Main Bus signal to be laid back onto the multitrack if required.
But before this can be done, the tracks to be used for this purpose must
first be assigned. Continue the set-up as follows:
4
The system must be unlocked to assign the multitrack busses which
will be fed from the Main Output Bus.
To assign the L channel for example, press and hold the { L } button,
and it lights.
5
Step through the multitrack busses using the SELECT TRACK { + }
and { - } buttons until the desired bus number is displayed in the 2
character display above the { L } button. This track has then been
assigned for the L channel of the Main Output Bus.
6
Repeat steps 4 and 5 for the other destination busses.
To Clear any Multitrack Bus Destinations
As an example, to clear the bus set up as the C channel:
7
Press and hold the { C } button and it lights.
8
Press the SELECT TRACK { + } and { - } buttons simultaneously to
clear the bus assignment for the C channel.