Sony OXF-R3 - Manual (Page 333)

Chapter 7 Session Management
7-73
Chapter 7 Session Management
To add a new cut:
Adding a new cut in between previous cuts, with no
overlap, is straightforward. Implement as previously
described.
ON
TIME
PREVIOUS
CUT
PREVIOUS
CUT
NEW CUT
CUT
How to modify cuts using READY TRIM
Note:
Although it is often easier to rewrite cuts rather than modify
them, the following online functions are available. (Offline
adjustments can be made using the OFFLINE: CUTS GUI).
1
‘Ready’ Trim enable the cuts to be automated with
the central {READY TRIM} button, or
‘Ready’ Trim enable the cuts using the ‘local’
method described at the beginning of this section.
3
Press {GLOBAL DROP-IN} either before or after
rolling the tape to drop all ‘ready’ enabled cuts into
automation record, or press switches individually.
4
Press {GLOBAL DROP-OUT} after writing cuts
followed by {PLAY} {ENTER} to hear the result
and note that automated cuts are indicated by
switches lighting amber.
5
Roll back and repeat {GLOBAL DROP-IN} until the
cuts are satisfactory.
6
Press {READY CANCEL} {ENTER} once cuts have
been completed.
Note:
The bi-colour LEDs in the cut switches help with the
operation of these functions. The red light indicates manual
actions and amber those being performed by the computer.
Extra bright red/amber indicates simultaneous manual and
computer control.