Sony OXF-R3 - Manual (Page 345)

Chapter 7 Session Management
7-85
Chapter 7 Session Management
CUES field
This field (lower right of screen), displays the CUES
list from the MIXES GUI. During OFFLINE CUTS
operations, this list also displays Cut Events in
timecode order.
SELECTOR block
The selector block on the upper left of the screen
allows the selection of the control type on which the
offline editing will be performed. Only one type of
control can be worked on at a time.
CHANS • Channel Faders & Cuts
MTSEND • Multitrack Send Faders & Cuts
CHSEND • 24 Send Levels & Cuts
(A Channel must be selected first,
then the appropriate Sends)
SNDMIX • All Channel Levels & Cuts for a
Single Send Bus
(The Send must be selected first,
then the appropriate Channels)
GROUPS • Control Group Faders & Cuts
SSGs • Super Send Group Faders & Cuts
SENDS • Send Bus Output Faders & Cuts
MAIN • Main Fader
ALL/NONE • Used in channel selection
RANGE • Used in channel selection
To set the duration
Data editing has to be within time constraints. The
time can be specified in three ways (FM = from):
Enter FM and TO
The DURATION is set automatically.
Enter FM and DURATION
The TO time is set automatically.
Enter TO and DURATION
The FM time is set automatically.
The FM and TO times can be entered either directly by
clicking on a timecode field for a pop-up or by using
cue times. Enter a cue time by highlighting that cue in
the cues list, then click on the bar below the FM or TO
legends to transfer the time. The cue time will be
entered and its name displayed. If a timecode set by
using a cue is subsequently altered, the cue name will
disappear.
To nudge times with the { + } and { - } keys on the
Control Keyboard, click on a timecode field for a pop-
up then nudge as required.
For faders, the transitions can be set as butt or ramp.
Click on the butt icon for it to change to ramp and vice
versa. Click on the ramp time for a pop-up to set the
ramp time. In and out ramps can have different times.
OFFLINE FADERS EDIT PROCEDURE
To select Faders
For Channel Faders, click on CHANS in the selector
block. It highlights red and the channel faders are
displayed in the numbers field. Click on the channels
to be worked and they highlight red. Click on them
again to de-select.
This procedure also applies to MTSEND, GROUPS,
SSGs and MAIN.
To select Sends
For Send levels for a particular channel, click on
CHSEND; it highlights red and the channels are
displayed in the numbers field. Click on the required
channel and its Sends, 1-24, are displayed in the
numbers field. Click on the required Sends and they
highlight red.
For a mix of all channels for a particular Send bus,
click on SNDMIX; it highlights red and Sends 1-24 are
displayed in the numbers field. Click on the required
Send and the channels are displayed in the numbers
field. Click on the required channels and they
highlight red.
Using ALL, NONE and RANGE
To select all faders of any type, click on ALL and all
numbers will be highlighted red. ALL will change to
NONE.