Sony OXF-R3 - Manual (Page 92)

4-32
Chapter 4 Signal Paths
Chapter 4 Signal Paths
4-13 Multi-Stem Set-up
Master Section set-up functions
The 8 character dot display to the left of this panel can display the format
for the Main Output Bus and that of M/T Stems.
If the {SET MAIN WIDTH} button is lit, the format for the Main Output Bus
is displayed: STEREO, LCRS, 5.1 or 7.1.
If the {SET MT STEMS} button is lit, the format for the M/T Bus is
displayed: STEREO, LCRS, 5.1 or 7.1. A stem reference, one of A–H,
will also be included if surround is in operation.
The Main Output Bus for the OXF-R3, which doubles as the M/T Monitor
Bus, has two basic modes of operation, Stereo or Surround. For Stem or
Multi-Stem operation the Main Output Bus must be set to a Surround
mode. Then M/T Busses can be assigned to stems which are configured
automatically to use the Main Output Bus for monitoring purposes.
Note
The width of stems, e.g. the number of busses in stems, is limited to a maximum
width no greater than the width of the Main Output Bus.
4-13-1 Multi-Stem Set-up Procedure
MULTI-FORMAT & STEREO SUB-GROUPS 1-16
LOCK
L C
MONO
R
CAL
DIM
CUT
M-F MON
BUS
MIX
R/C L/C
L-S SUB R-S
1
EXT
1
EXT
3
EXT
2
EXT
4
EXT
5
EXT
6
4 6
3, 5
7, 10
9
SET
MAIN
WIDTH
SET
MT
STEMS
2