Sony OXF-R3 - Manual (Page 151)

Chapter 5 Control Screens
5-37
Chapter 5 Control Screens
INSERT SEND – Second field
The second field is used to specify an I/O destination for the selected Insert
Send. Click on this for a pop-up displaying possible destinations. Click
on the desired DAC to assign an analogue Send or, for a digital output,
click on AES for the digital destinations. Further pages of related pop-ups
can be accessed by clicking on Prev. or Next. Click on OFF to disable a
Send.
INSERT RETURN – Third field
The third field is used to select the I/O Insert Return source for the
channel. Click on this for a pop-up displaying possible return sources.
Click on the desired ADC for an analogue return source or click on AES
for the digital return sources. Further pages of related pop-ups can be
accessed by clicking on
“ or ”. Click on OFF to disable a Return.
WORD LENGTH – Fourth field
The fourth (lowest) field allows the insert Send and Return word length to
be set, if the insert device is digital. Click on it to cycle through the word
lengths 16 bit, 20 bit and 24 bits. It will be set for both send and return
simultaneously.
Although the word length field is operable when analogue I/O is selected, it only
affects digital I/O.
The Softkeys for this GUI:
• TOP - Selects the top level LOGO screen
Note: