Sony OXF-R3 - Manual (Page 146)

5-32
Chapter 5 Control Screens
Chapter 5 Control Screens
5-2 Channel Screens
GDC DISPLAY (Global Delay Compensation)
Option to set what is displayed in the 8 character dot display above the
Global Display Compensation knob on the Free Assign Area & Dynamics
panel.
• ALWAYS
- Units of delay are indicated continuously.
• WHEN MOVING - GLOB DEL displayed until the knob is moved,
when the units of delay are indicated, and remains
for 3 seconds after release of the knob.
AUTO RAISE
• LEFT - EQ & Dynamics GUIs are automatically displayed in
the left channels section, above respective panels,
when any EQ or Dynamics controls are adjusted.
• RIGHT - EQ & Dynamics GUIs are automatically displayed in
the right channels section, above respective panels,
when any EQ or Dynamics controls are adjusted.
REPEAT RAISE
When assigning I/O, clicking on the source or destination device normally
causes the pop-up to close. With the use of Repeat Raise, the pop-up
remains open and increments the channel number for the same input or
output for a further assignment and so on. Click on the red title bar at the
top left when completed.
• LEFT
- Repeat Raise operates for the left side of the console.
• RIGHT - Repeat Raise operates for the right side of the console.
RANGE
• DISABLE - Disables the Range function.
• ENABLE - Allows consecutive numbered sections of I/O devices,
of the same type, to be assigned to consecutive
numbered sets of channels when using the I/O GUI.
CAL MODE
Relates to the Surround LS Calibration settings for mixing to picture.
• ON
- LS1 Monitor Outputs use their calibration settings.
• OFF - LS1 Monitor Outputs default to uncalibrated settings.
SADDLE BUTTON
Option to allow the buttons in the middle of the Fader Knobs to be used for
two different functions:
• PFL
- Momentary PFL operation.
• AUTOMATION - Fader Automation drop-in to record fader moves.
FADER STARTS 1 & 2
Two GPIO relay closure Fader Starts can be assigned to Channel or
Control Group Faders.
• Upper Button - Click on to cycle through CHANNEL and GROUP
Faders or OFF.
• 4 $ Buttons - Click to select the Channel or Group Fader number.