Sony OXF-R3 - Manual (Page 320)

7-60
Chapter 7 Session Management
Chapter 7 Session Management
7-6 The Session Management™ Screen Pages
7-6-10 Copy Monitor and M/T Send Fader Balance to Cues
General
This function allows the copying of the Main Output
Bus balance (serves as monitor bus) and the M/T Send
Fader balance to any of the Send busses. This copy
can be carried out for one bank of 24 channels at a
time or all channels simultaneously.
Copy Monitor mix from ALL CHANNELS
On the Select To Faders panel, press and hold
{CHANS} until it turns amber. Then press the desired
{SEND ‹} button on the same panel. Release {CHANS}.
Note
The destination {SEND ‹} remains assigned to the faders
after such an operation.
Copy Monitor mix from ALL M/T SENDS
On the Select To Faders panel, press and hold
{M/T SEND} until it turns amber. Then press the
desired {SEND ‹} button on the same panel. Release
{M/T SEND}.
Note
There are 120 CHAN faders and 72 M/T SEND faders in the
largest configuration.
Copy mix from a bank of 24 CHANNELS
On the Select To Faders panel, make sure {CHANS} is
selected then press and hold the source bank button,
{CHS 1-24} for example, until it turns amber. Then
press the desired {SEND ‹} button on the same panel.
Release {SEND ‹}.
Copy mix from a bank of 24 M/T SENDS
On the Select To Faders panel, make sure
{M/T SENDS} is selected then press and hold the source
bank button, {CHS 1-24} for example, until it turns
amber. Then press the desired {SEND ‹} button on the
same panel. Release {SEND ‹}.
7-6-11 Quick Copy EQ A to B and B to A
On the EQUALISER & FILTERS panel, press and
hold { A } until it turns amber, then press { B }. Reverse
this procedure to copy { B } to { A }.
General
This function allows the copying of the Main Output
Bus balance (serves as monitor bus), set by the
Channel Faders, to the M/T Send Faders balance and
vice versa. This will also include Surround Pan
settings.
Copy Channel Faders to M/T Send Faders
On the Select To Faders panel, press and hold
{CHANS} until it turns amber. Then press the
{M/T SEND} button.
7-6-9 Copy Channel Fader Balance to M/T Faders and M/T to Channels
Note
{M/T SEND} remains selected.
Copy M/T Send Faders to Channels
On the Select To Faders panel, press and hold
{M/T SEND} until it turns amber. Then press the
{CHANS} button.
Note
{CHANS} remains selected.
All knob and switch settings get copied along with the
Equaliser Type. Default settings copy automation data
too. This may be set in the ‘config set-up’ to copy
static settings only.