Sony OXF-R3 - Manual (Page 109)

Chapter 4 Signal Paths
4-49
Chapter 4 Signal Paths
STEM monitor switch functions
1 SENDS Push-Button(s)
Selects the sources being sent to tape for its stem or stems and inter-
cancels with {RETS}.
2 RETS (Returns) Push-Button(s)
Selects the return signal from tape for its stem or stems and inter-cancels
with {SENDS}.
Note
In Multi-Format Mode, the {SEND} and {RET} buttons for channels assigned as
Stem masters also inter-cancel.
3 SOLO Push-Button(s)
Solos its stem or stems.
4 CUT Push-Button(s)
Cuts its stem or stems.
Stem monitor switching hierarchy
The monitor switching is controlled top down allowing the flexibility of
local overrides at the slave channel level. Pressing either {SENDS} or
{RETS} on the remotes panel in order to change the monitor source will re-
synchronise slaves on the first press, if any channels have been overridden
locally. A subsequent press will cause the monitor source to change.
The same principle applies to the master buttons in the GUI described in
the next section, 4-13-5.