Sony OXF-R3 - Manual (Page 145)

Chapter 5 Control Screens
5-31
Chapter 5 Control Screens
SELECT
Allows a one-shot print function of Mixer GUIs, such as I/O set-ups, using
the SELECT buttons below the LCD screens in the channel sections.
• PRINT
- Click on PRINT. Then, pressing SELECT below any
LCD in the channels sections will cause an image
of the GUI displayed to be printed, provided that the
cursor is already in that screen. The selector then
reverts to the normal SELECT function. PRINT must
be clicked on again to print a second or further GUI.
• SELECT - Default function setting for the SELECT buttons
below the LCD screens in the channel sections.
This print output function requires the system to be configured with a Postscript
compatible printer.
MONO MEANS
Sets the destination LS when, for a mono signal, {MONO} is selected at the
Monitor panel.
• CENTRE
- Mono signal fed to the Centre LS.
• LEFT & RIGHT - Mono signal fed to both the Left and Right LS.
MODES for COMMUNICATIONS BUTTONS
There are three button modes for each of CUE, SLATE and TBACK as
below. Click on the buttons to the right of these labels accordingly.
• MOM(entary) - Press and hold.
• LATCH(ing)
- Press for on and press again for off.
• AUTO - Combination mode: Press and hold for a momentary
function, or short press to latch and another short
press to release.
LEVEL BOOST
Click on AFL, PFL or SOLO and then click on the 4 and $ buttons to
adjust monitor level beyond the default unity gain.
• AFL
- Allows boost of up to 20dB in 1dB steps.
• PFL - Allows boost of up to 20dB in 1dB steps.
• SOLO - Allows boost of up to 20dB in 1dB steps.
I/O REDIRECTION
• ALIAS - The specified ‘alias’ names, such as MIC 1, are
displayed for I/O legends.
• RAW - The ‘raw’ names such as ADC 1 are displayed for I/O
legends.
STEM CLEARING
• MANUAL - Channel to stem routing is totally flexible allowing
routing to multiple stems. Routing selections must be
cleared manually.
• AUTOMATIC - Channel to stem routing selections for a particular
Stem will be cleared automatically if another stem is
selected. In other words, channels can route only to a
single stem.
Note: