2-2 select to faders panel – Sony OXF-R3 User Manual
Page 171
Chapter 6
Technical Descriptions
6-9
Chapter 6 Technical Descriptions
The following illustration shows the left Select to Faders Panel, which is
located immediately to the left of the centre section of the control surface.
The right hand Select to Faders Panel, located immediately to the right of
the centre section, has a panel layout which is a mirror image of the one
described here.
This Panel assigns fader banks to control desired signal paths.
The various push-buttons allow assignment of signal paths to channel
faders as per button designation and the previous Fader description.
Channel faders may be switched to control:
• INPUT GAIN
Gain of Mic, M/T and Line
• M/T SEND
Level sent to M/T bus
• GROUP TRIM
Gain of M/T Bus Output to M/T Channel
• M/T MONITOR
Level Sent to Independent M/T Monitor Bus
• CHANNEL
Channel Level Sent to Main Output Busses
• SUPER SGs
Levels Sent to Super Send Group Outputs
• SENDS
Levels Sent to Effects & Foldback Outputs
• SUB LEVEL
Levels Sent to the Sub Bus in Multi-Format Mode
6-2-2 Select to Faders Panel