Sony OXF-R3 - Manual (Page 232)

6-70
Chapter 6 Technical Descriptions
Chapter 6 Technical Descriptions
6-3 Central Section Panels
{MAKE STATIC} # . . # {ENTER}
Removes the moves data from the working mix for a range of channels
# . . # for controls according to the Snapshot DEFAULTS in the Snapshots
GUI (see page 6-65 for details of how to specify Ranges and Lists).
“MERGE” Command Lines
Note:
Comprehensive control of “MERGE” functions is available via GUI and is
described in Chapter 7.
MERGE command lines require ranges and/or lists to be specified (see
page 6-65 for details of how to specify Ranges and Lists). Mix data can be
copied and pasted in the working mix or imported from other mixes.
Snapshot settings can also be merged into mixes.
The MERGE Command Line has the general form:
{MERGE} (Source Range/List) from (Specified Start Time) to (Specified
End Time) to (New Specified Start Time) {ENTER}
Times can be specified in various ways: { A }, { B }, {CUE}, {CUE} # or
typed in using the numeric keypad on the Control Keyboard. Where
timecode is typed in, a blank { } or {TO} key must be used between
numbers as a separator. Examples:
{MERGE} 1..48 {MIX} {CUE} 3 {CUE} 6 {CUE} 9 {ENTER}
Adds a new automation layer to the working mix that copies all the moves
for channels 1-48 between Cue 3 and Cue 6 to repeat starting at Cue 9.
{MERGE} 1..2 {SNAPSHOT} { A } { B } {ENTER}
Adds a new automation layer to the working mix that will switch to the
currently highlighted Snapshot settings at point A and back to existing data
at point B for channels 1 and 2.
{MERGE} 01..032 {MIX} # { } 2:00 {TO} 4:00 {TO} 2:00 {ENTER}
Adds a new automation layer to the working mix that will switch to the
Control Group Faders move data for Mix # between 2:00 and 4:00
minutes.
“PROJECT” Command Line
{PROJECT} {ENTER}
Creates a new Project.
“TITLE” Command Line
{TITLE} {ENTER}
Creates a new Title.