Sony OXF-R3 - Manual (Page 93)

Chapter 4 Signal Paths
4-33
Chapter 4 Signal Paths
1
The {LOCK} push-button is normally lit, indicating that the set-up is
locked. Press to unlock, indicated by the light going off. This button
will time out back to lock status 10 seconds after the last button press.
Note
A Config. Set-up option enables the {LOCK} button as a level of security, i.e. it
must be unlocked to allow bus assignment set-up.
2
While the system is unlocked, press the {SET MAIN WIDTH} button to
check that the Main Bus width matches requirements if not already
displayed.
3
If it does not, while the system is unlocked, use the { + } or { - } button
to step through the formats: STEREO, LCRS, 5.1 and 7.1 until the
desired format is displayed by the 8 character display above the
{LOCK} push-button.
4
While the system is unlocked, press the {SET MT STEMS} button.
5
While the system is unlocked, use the { + } or { - } button to step
through the formats: STEREO, LCRS, 5.1 and 7.1 until the desired
type is displayed by the 8 character display above the {LOCK} push-
button. An ‘A’ will be displayed initially to the right along with each
format type, indicating that the settings displayed are for Stem A. If
the system has already been in use, then other letters, B-H, may be
displayed depending on how the system was left.
To select another Stem make sure that {LOCK} is lit, by pressing it or
allowing it to ‘time out’, then use the { + } or { - } buttons either side of
the 8 character display to step through stems A-H.
6
Multitrack busses are used as Multi-Stem master busses and must be
selected as part of the set-up. The system must be unlocked to assign
the multitrack busses.
To assign the L channel for example, press and hold the { L } button,
and it lights.
7
Step through the multitrack busses using the SELECT TRACK { + }
and { - } buttons until the desired bus number is displayed in the 2
character display above the { L } button. This track has then been
assigned for the L channel for the Stem, one of A-H, indicated in the 8
character display. The track button in the ROUTE GUI will display a
colour-coded outline, indicating that it has been assigned to a Stem.
8
Repeat steps 6 and 7 for the other busses required in the current Stem.
To assign busses for another Stem, make sure that {LOCK} is lit, by
pressing it or allowing it to ‘time out’. Then use the { + } or { - }
buttons either side of the 8 character display to step through Stems A-
H to the one which is required. Then repeat steps 6 and 7 for each of
the busses required in that Stem.