Kyocera FS-C1020MFP - Manual (Page 157)

Top Page > Getting Started > Entering Characters > Text Input Mode
Text Input Mode
Text input mode becomes active when entering names.
Available characters
Letters, numbers, and symbols can be entered.
In this mode, use the keys as follows:
●
To enter a character
Press a number key repeatedly until the desired character appears.
When entering two characters that use the same number key successively, press the [ ] key
after entering the first character.
●
To insert a space
Place the cursor where you want to insert a space, and then press and hold the [ ] key until
a space is inserted. To enter a space at the right-most position, press the [ ] key twice.
●
To move the cursor left or right
Press the [ ] key to move the cursor left, and the [ ] key to move the cursor right.
If you enter a character when there is a character at the cursor position, the current character
shifts to the right.
●
To delete a character
Place the cursor on the character you want to delete, and then press and hold the [ ] key
until the character is deleted.
●
To delete all characters
Press the [Clear/Stop] key.
●
When the maximum number of characters has already been entered, characters entered subsequently are ignored.
Top Previous Next
Copyright © 2009
Contents Previous Next Settings