Kyocera FS-C1020MFP - Manual (Page 223)

To scan in black and white, press the [B&W Start] key.
To scan in color, press the [Color Start] key.
Depending on the machine's settings, you may be prompted to place another original on the exposure
glass. In this case, proceed to the next step.
If you have more originals to scan, place the next original on the exposure glass, and
then press [1]. Repeat this step until all originals are scanned.
When all originals have been scanned, press [2] to start sending the scanned file.
●
To cancel scanning, press the [Scanner] key, and then press the [Clear/Stop] key. The scan files are discarded.
●
When you specify a scan destination, the machine's scan settings change automatically according to the information
registered for that destination in the Address Book. If necessary, you can change the scan settings using the control panel.
●
You can also specify a destination using the One Touch buttons or [Pause/Redial] key.
●
If the [Limitless Scan] setting under scanner settings is enabled, you can place originals on the exposure glass repeatedly
in a single scan procedure.
●
If the [Multi Page in A Document] setting under scanner settings is enabled, you can scan multiple pages to create a single
PDF or TIFF file containing all pages. However, if the file format is JPEG, a single-page file will be created for every page
scanned.
●
If paper is jammed in the ADF, the scan file is discarded. In this case, scan the entire originals again. To remove paper
jams in the ADF, see Removing Scanning Jams .
●
To place the original, see Placing Originals .
●
To configure advanced scan settings, see Specifying the Scan Settings .
●
For details about specifying the scan destination, see Specifying the scan destination .
●
For details about [Multi Page in A Document] or [Limitless Scan], see Scanner Settings .
●
For details about how to remove the paper jammed in the ADF, see Removing Scanning Jams .
Related topics
Specifying the scan destination
Top Previous Next
Copyright © 2009