Kyocera FS-C1020MFP - Manual (Page 73)

Top Page > Getting Started > Installing the Machine > Unpacking
Unpacking
To protect it from shock and vibration during transit, this machine comes packaged in cushioning foam and
secured with tape. Remove these protective materials after bringing the machine to where it will be
installed.
●
Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame.
Dispose of used toner containers in accordance with local regulations.
●
Do not store toner, used toner, or toner containers in a place with an open flame. The toner might ignite
and cause burns of a fire.
●
Keep toner (used or unused) and toner containers out of reach of children.
●
If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult
a doctor if necessary.
●
If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor
if necessary.
●
If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if
necessary.
●
When moving the machine, use the inset grips on both sides. The machine will break or cause injury if
dropped.
●
Removed tape is dirty. Be careful not to let it touch your hands or clothes.
●
Leave the protective materials in place while moving the machine.
●
Lower the machine slowly and carefully to prevent trapping your hands.
●
Do not grip on the tray area when lifting the machine.
●
Do not allow paper clips, staples, or other small objects to fall inside the machine.
●
Keep uncovered print cartridges away from direct sunlight.
●
Do not touch the print cartridge's photo conductor unit.
●
Do not touch the ID chip on the side of the print cartridge (the white area in the illustration below).
Contents Previous Next Settings